Connecting The System - Pioneer AVIC-F130 Owner's Manual

Chapter
13 Installation

Connecting the system

AV receiver
TMC aerial (supplied)
Attach the GPS aerial to
the "GPS ANTENNA" jack
on the side of this product.
3 m
GPS aerial (supplied)
Affix the double-sided tape (supplied)
on the surface as level as possible
where the GPS aerial faces the
window. Place the GPS aerial on the
double-sided tape.
68
Engb
RGB cable (supplied)
2.65 m
TMC aerial IF
Yellow (B+)
To the terminal that the power is always supplied
Fuse (3 A, 250 V)
regardless of the ignition switch position.
Insert one end of the RGB cable into the "DATA BUS"
slot on the side of this product and secure it with an
11 mm (.4 in) screw (supplied). Connect the other
end of the cable to RGB IN input on the back of your
Pioneer AV receiver.
2 m
Where applicable, secure the cable to
the AV receiver using an 11 mm (.4 in)
screw (supplied).
The navigation unit
Power cord (supplied)
Black (GND)
To vehicle (metal) body.
Secure the RGB cable with
the 11 mm (.4 in) screw