Kaisai KOU-12HDN1 Service Manual page 143

MLCAC-UTSM-2010-10
1.3 R51/CE
The R51/CE wireless remote controller is only for MCA1-18CR.
Remote Controller Specifications
Rated Voltage
Lowest Voltage of CPU Emitting Signal
Reaching Distance
Environment Temperature Range
Introduction of Function Buttons on the Remote Controller
1. TEMP DOWN Button: Push the TEMP DOWN button to decrease the indoor temperature setting or to
adjust the timer in a counter-clockwise direction.
2. MODLE SELECT Button: Each time you push the button, a mode is selected in a sequence that goes
from AUTO, COOL, DRY, HEAT and FAN as the following figure indicates:
3. SWING Button: Push this switch button to change the louver angle.
4. RESET Button: When the RESET button is pushed, all of the current settings are cancelled and the
control will return to the initial settings.
5. ECONOMIC RUNNING Button: Push this button to go into the Energy-Saving operation mode.
6. LOCK Button: Push this button to lock in all the current settings. To release settings, push again.
7. CANCEL Button: Push this button to cancel the TIMER settings.
8. TIMER Button: This button is used to preset the time ON (start to operate) and the time OFF (turn off the
operation)
9. ON/OFF Button: Push this button to start the unit operation. Push the button again to stop the unit
operation.
Control
Model
Wireless Remote Controller
R51/CE
3.0V
2.0V
8m (when using 3.0 voltage, it can get 11m)
-5 ℃ ～ 60 ℃
139