Installing The Integrated Storage Controller Card; Heat Sinks And Processors - Dell PowerEdge R430 Owner's Manual

2. Follow the procedure listed in
Related Links
Removing the cooling shroud
Installing the cooling shroud

Installing the integrated storage controller card

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
2. Follow the procedure listed in
3. Remove the cooling shroud.
4. Keep the #2 Phillips screwdriver ready.
Steps
1. Align the end of the integrated storage-controller card with the integrated storage-controller card
holder.
2. Lower the connector side of the integrated storage-controller card into the integrated storage-
controller card connector on the system board.
Ensure that the tabs on the system board align with the screw holes on the integrated storage-
controller card.
3. Align the screws on the integrated storage-controller card cable with the screw holes on the
connector.
4. Tighten the screws to secure the integrated storage-controller card cable with the integrated
storage-controller card connector on the system board.
Next steps
1. Replace the cooling shroud.
2. Follow the procedure listed in
Related Links
Removing the cooling shroud
Installing the cooling shroud

Heat sinks and processors

Use the following procedure when:
• Installing an additional processor
• Replacing a processor
NOTE: To ensure proper system cooling, you must install a processor blank in any empty processor
socket.
92
After working inside your
Safety instructions.
Before working inside your
After working inside your
system.
system.
system.