Two-Speed Rear Axle Electric Shift Control - Chevrolet Kodiak 2006 Owner's Manual

Two-Speed Rear Axle Electric Shift
Control
If your vehicle has this feature, you will find a label on
the headliner above the windshield or in another
place near the driver that shows how to use it. Be sure
to follow the directions carefully.
Use the following directions based on the type of shift
control the vehicle has.
When the switch is down, the rear axle is in the high
range. When the switch is up the rear axle is in
low range. Push or pull the switch to change the range.
2-28
The rear axle shift control
switch for a manual
transmission is located on
the shift lever.
The two-speed axle should be in the up position or low
range when you park the vehicle. You will need to
engage the transmission and move the vehicle a little to
assure the axle is in the low range. Then apply the
parking brake, shift into NEUTRAL and shut off
the engine.
Also, always start the vehicle in motion with the
two-speed axle in the low range.
To shift up from low to high, do the following:
1. Move the switch down for the high range.
2. Disengage the clutch.
3. After a brief pause, engage the clutch and then
press down on the accelerator pedal until the
axle engages.
To shift down from high to low, do the following:
1. Release the accelerator and pull the switch upward
for low range.
2. Press the accelerator pedal slowly until the axle
engages.