Connecting The Power Supply; Connecting The Interface Cable - Samsung SRP - 770 Operator's Manual

3. Connecting the Power Supply

CAUTIONS:
When connecting or disconnecting the power supply from the printer, make sure that
the power supply is not plugged into an electrical outlet. And the power supply's
rated voltage and your outlet's voltage do not match, contact your dealer for
assistance. Then do not plug in the power cord. Otherwise, you may damage the
power supply or the printer.
1. Make sure that the printer's power switch is turned off, and the power supply's
power cord is unplugged from the electrical outlet.
2. Check the label on the power supply to make sure that the voltage required by the
power supply matches that of your electrical outlet.
3. Plug in the power supply's cable as shown below. Notice that the flat side of the
plug faces down.
6

4. Connecting the Interface Cable

Universal Serial Bus Parallel Interface
(USB)
* Note
Defaultly, you can use Serial and Parallel Interface.
If you want to use USB Interface, please turn on the
Serial Interface
RS-232 default
setting is 19200 baud,
no parity, 8 data bits
and 1 stop bit
Dip S/W2-
4
7