Contents Of Snap-In Rail-Mounting Kit; Installing The Snap-In Rails - HP StorageWorks 2500 User Manual

Locate the following components, which were ordered separately:
• Disk drives
• FC cables
• FC cable labels
Installing the DS2500
This section describes the procedure to install the DS2500:
1. Installing the snap-in
2. Reducing the enclosure
3. Installing the DS2500 in the
4. Connecting the
5. Setting the enclosure ID
6. Setting the enclosure loop ID
7. Verifying the
NOTE:
HP recommends that you install the heaviest components low in the rack to ensure rack stability.

Installing the snap-in rails

1
2
1. Left rack rail
2. Right rack rail
3. Pins for round-hole rack conversion (8)
Figure 10 Contents of snap-in rail-mounting kit
You can identify the left and right rack rails by the markings (L) and (R) stamped into the sheet metal.
NOTE:
The rail kit contains adapter brackets that are used when mounting some devices in the rails; however
these brackets are not used when mounting a DS2500.
26
Installation
rails, page 26
weight, page 29
rack, page 31
cables, page 33
(En), page 34
(Li), page 35
installation, page 36
3
CXO8193A