Table of Contents
Advertisement
C.
Slide belt through slot in belt clamp.
D.
Verify belt and insert are installed properly, as,shown
in Figure 8A. NOTE: Do not install the insert backwards
as shown in Figure 8B.
E.
Pull belt tight and secure belt to clamp with the two
set screws. NOTE: Torque set screws 300-350 in./lbs.
See Figure 9.
F.
Place weight stack pin in each plate to verify proper
installation.
G.
Without selecting any resistance, lift top weight up
and down (simulating normal operation).
H.
Have an assistant verify that the belt is moving smoothly
and is routed straight from the top pulley bracket to the
top weight belt clamp.
I.
Reinstall the six increment weights that were removed
in step 6B. See Figure 10.
J.
Turn the Increment Weight Adjusting Kob to select
all 15 lbs.
8. Install back shrouds.
A.
Carefully place shroud assembly back into position
on the two bottom screws. See Figure 11.
B.
Install the top two screws securing the back
shroud assembly. See Figure 12.
Assembly
Page 4-4
Cybex Eagle 11050 Leg Extension Owner's Manual
Correct belt routing
Insert
Belt
Stem
Figure 8A
Belt
Set screw
Figure 9
Increment
Weights
Figure 10
Figure 11
Figure 12
Wrong belt routing
Insert
Belt
Stem
Figure 8B
Belt clamp
insert
Belt clamp
Screw
Screw
Advertisement
Table of Contents
