Table of Contents
Advertisement
C.
Using an external snap ring pliers, remove the upper
snap ring from one of the guide rods and carefully lower
the guide rod. See Figure 5.
D.
Remove lower snap ring and wave washer from the
guide rod. Repeat steps 6C and 6D to remove both snap
rings from other guide rod.
E.
If possible, lean guide rods outward, away from machine
in order to provide the most room for installing weight
plates.
F.
Slide top weight up and out of machine and carefully set
it aside.
G.
Wipe guide rods clean over entire length. Lubricate with
light coating of medium weight automotive engine oil.
H.
Carefully install each weight plate one at a time.
edges of bushing face upward and narrow edges of bushing face downward. See Figures 6A and 6B.
Figure 6A
I.
Slide top weight onto guide rods.
J.
Place lower snap ring and wave washer onto guide
rod (about 3" from the top end of guide rod).
K.
Raise guide rod up through mounting hole and install
the upper snap ring.
L.
Lower guide rod and secure lower snap ring.
Repeat steps 6J - 6L for the other guide rod.
7. Belt Routing.
A.
Verify belt is routed through top of pulley bracket
and then route end of belt down to the top weight.
B.
Verify the belt clamp on the top weight is positioned properly with the top pulley.
have a straight path from the pulley to the belt clamp. See Figure 7. NOTE: Figure 7 shows the top view,
looking from the top pulley down to the top plate.
Cybex Eagle 11050 Leg Extension Owner's Manual
NOTE: When installing weight plates, position plates so wide
WIDE bushing
edge faces
upward
Frame
Figure 5
NOTE: The narrow bushing
edge must face downward.
Figure 6B
Belt
Top Pulley
Increment
Weight
Adjusting
Knob
Figure 7
NOTE: The belt must
Upper snap ring
Wave washer
Lower snap ring
Guide rod
NARROW
bushing edge
Set Screw
Insert
Assembly
Page 4-3
Advertisement
Table of Contents
