Makita EA3200S Original Instruction Manual page 17

instruction manual (Fig. 9)
- When working with the chain saw always hold it with
both hands.
- CAUTION: When releasing the throttle lever the chain
will keep on running for a short period of time
- Switch off the chain saw immediately if you observe
any changes in its operating behavior.
- The engine must be switched off before checking the
chain tension, tightening the chain, replacing it or
clearing malfunctions (Fig. 10)
such as through impact or falling, inspect the entire chain
(Fig. 10)
Maintenance
Refuelling
Sharpening the chain
CAUTION: Do not put the overheated power chain
- CAUTION: Oil dropping from the chain or guide bar after
3-6. Kickback
objects (Fig. 11)
In order to prevent kickback, follow these rules:
- Only specially-trained persons should perform plunge
-
3-7. Working behavior/Method of working
Stopping work
Transport
Putting out of function
Risk of injury!
(Fig. 13)
- Remove foreign objects such as sand, stones and nails
jack, Fig. 14
- For cutting down trees or performing crosscuts the
spike bar Fig. 14 must be applied to the wood to
be cut.
- Before performing a crosscut
the tubular handle and simultaneously pulling back the
- When the timber must be pierced for cutting or
longitudinal cuts are to be performed it is urgently
recommended to have this carried out by specially
trained persons only
- When starting a cut, the blade can slip to the side or jump
Therefore, always hold the chain saw with
both hands.
longitudinal - lengthwise - cuts
possible angle (Fig. 15)
- When performing several cuts the throttle lever must be
CAUTION:
People felling trees or cutting of branches must be
specially trained. High risk of injuries!
supported on the trun
(Fig. 12)
(Fig. 12)
(Fig. 16)
(Fig. 17)
amping of the guide bar can