Installation Precautions - Kyocera FS FS-9530DN Operation Manual

Installation Precautions

Environment
Left: 300 mm
Other Precautions
OPERATION GUIDE
Avoid placing the machine on or in locations which are unstable
or not level. Such locations may cause the machine to fall down
or fall over. This type of situation presents a danger of personal
injury or damage to the machine.
Avoid locations with humidity or dust and dirt. If dust or dirt
become attached to the power plug, clean the plug to avoid the
danger of fire or electrical shock.
Avoid locations near radiators, heaters, or other heat sources, or
locations near flammable items, to avoid the danger of fire.
To keep the machine cool and facilitate changing of parts and
maintenance, allow access space as shown below. Leave
adequate space, especially around the vents, to allow air to be
properly ventilated out of the printer.
(12 inches)
Always use the caster stoppers to stabilize the printer once it is
in place to keep it from moving and/or falling over and causing
injury.
Adverse environmental conditions may affect the safe operation and
performance of the machine. Install in an air-conditioned room
(recommended room temperature: around 23°C, humidity: around 60%
RH), and avoid the following locations when selecting a site for the
machine.
• Avoid locations near a window or with exposure to direct sunlight.
CAUTION:
Right: 300 mm Rear: 100 mm
(12 inches) (4 inches)
Front: 1,000 mm
(40 inches)
xix