Firmware Environment Commands - Kyocera ECOSYS P2235dn Service Manual

(2) Firmware environment commands

The printer maintains a number of printing parameters in its memory. These parameters may be changed per-
manently with the FRPO (Firmware RePrOgram) commands.
This section provides information on how to use the FRPO command and its parameters using examples.
Using FRPO commands for reprogramming the firmware
The current settings of the FRPO parameters are listed as the optional values on the service status page.
Note: Before changing any FRPO parameters, print out a service status page, so you will know the parameter-
values before the changes are made. To return FRPO parameters to their factory default values, send the-
FRPO INIT (FRPO-INITialize) command. (!R! FRPO INIT; EXIT;)
The FRPO command is sent to the printer in the following sequence:
!R! FRPO parameter, value; EXIT;
Example: Changing emulation mode to PC-PR201/65A
!R! FRPO P1, 6; EXIT;
FRPO parameters
Items
Message language selection at
power-up
Default pattern resolution
Number of copies at start-up
Page orientation
Default font*
PCL font switching
Total host buffer size
Form feed time-out value
Reduction (100 V model only)
Auto linefeed mode (100 V model
only)
(Japanese emulation only)
Horizontal offset (100 V model
only) *
FRPO
B7 0: Entering into the language selection menu
1: Not entering the language selection menu
B8 0: 300 dpi
1: 600 dpi
C0 1 to 999
C1 0: Portrait
1: Landscape
C2 Middle two digits of power-up font
C3 Last two digits of power-up font
C5 First two digits of power-up font
C8 0:HP compatible mode
32:Compatibility mode
H8 0 to 99 in units of the size defined by FRPO S5
H9 Value in units of 5 seconds (0 to 99).
J0 0: 100%
5: 70 %
6: 81 %
7: 86 %
8: 94 %
9: 98 %
J7 0: Auto linefeed
1: No auto linefeed
K0 -7 to +7 (Integer), unit: cm
K1 -99 to +99 (Decimal), unit: 1/100 cm
9-2
2RV/2RW/2RX/2RY/3RA
Setting value Factory set-
ting
1
0
1
0
0
0
0
0
5
6
1: 100V
0
0
0
0