Haier JC-160GDD Service Manual page 18

The wine cel lar is preset in the
temperature requirements for red or white wines.
The wine cellar can be set
either of the com partments to acco mmodate your wine st orage requirements.
To set the temperature, hol d the "set" button for about 3 seconds,you will
notice the temperature display bl inking for the upper comp artment. Press the
up or down arrow button to i
setting.Once the desired temperature is attained ,press the "Set" button.Doing
this, the electronic control p anel will memorize the setting.The temperature
display w ill revert back to display the
time to reach the set temperature.
Light control:
Normally,when you open the door ,the LED light is on and when you close the
door ,the LED light is of f.If you want to keep the LED light on af ter you close the
door ,you can open the door and press the "light" button,and you can notice
that the LED light is on af
the"light" button again, the LED light is on but it is closed after you close the door.
4. Failure code display
Some times the di splay works out of orders,reading the following contenti on
may give you some help.
CONTROL AND DISPLAY SYSTEM
factory to automatical ly accommodate
to any temperature between
ncrease or decrease the temperature
inside temperature.It may t ake some
ter you closed the door .Open the door and Press
１７
6°C and 18 °C in