Yamaha F50A Service Manual page 195

4. Install the shift rod bolts 6, shift rod 7
and power trim and tilt relay 8.
5. Connect the flushing hose (models with
flushing device), pilot water hose 9,
trailer switch coupler 0 (EHT, ET), warn-
ing indicator coupler A (EHD, EHT),
ground lead B (EHT, ET), PTT motor
leads C (EHT, ET), PTT relay leads D
(EHT, ET), 10-pin coupler E, and battery
leads F.
62Y3A11
6. Connect the throttle link rod G and fuel
hose H.
7. Connect the shift cable/shift rod I and
throttle cable J, and then adjust their
lengths. For adjustment procedures, see
Chapter 3, "Checking the throttle cable
operation," and "Checking the gearshift
operation."
Cylinder body
5-68
1
2
3
4
5
6
7
8
I