Safety And Operating Notes; Figure 3-1. Laser Safety Warning - Fluke 830 User Manual

3. Safety and operating notes

The Product is to be used in industrial environments for shaft alignment only.
Care must be taken to ensure that the Product is not subjected to mechanical
knocks. It must be operated by properly trained personnel only. No liability will be
assumed when components or operating procedures as described in this manual
are not followed, or altered without permission of the manufacturer.
Operating tip
A Note denotes general information and tips regarding operation of the Product.
IP classification
The Product is dust-tight and protected against water jets (IP65). The sensor and
prism comply with code IP67 (dust-tight and protected against immersion).
Laser safety
This product uses a Class 2 laser. The laser complies with the requirements of
IEC/EN 60825-1 and FDA 21 CFR 1040.10 and 1040.11 with Laser Notice 50.
The laser operates at a wavelength of 670 nm with a pulse duration of 128 μs,
a maximum radiated power of 0.8 mW and a maximum energy of 0.1 μJ. No
maintenance is necessary to keep the product compliant as outlined above.
• Do not stare into beam. Do not point laser directly at persons or
animals or indirectly off reflective surfaces.
• Do not look directly into the laser with optical tools (for example,
binoculars, telescopes, microscopes). Optical tools can focus the
laser and be dangerous to the eye.

Figure 3-1. Laser safety warning

Warning
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
λ=650nm,<1mW,EN60825-1:2007
COMPLIES WITH 21 CFR 1040.10
AND 1040.11
Safety and operating notes
Laser safety
7