Turning The Power On - Canon imageFORMULA P-208II User Manual

Auto Start Switch
There is an Auto Start switch at the rear of the scanner for setting whether
to operate the scanner as a storage device.
Depending on the position of the Auto Start switch, the scanner operates
as shown below.
Switch
Position
The scanner is recognized as a storage device by the
computer. Starting CaptureOnTouch Lite preinstalled in
the scanner enables you to perform scanning on a
ON
computer without the scanner driver installed. (However,
you cannot store scanned images or any other data on
the scanner.)
The scanner is recognized as a scanning device by the
computer. You can connect the scanner to a computer
OFF with the scanner driver installed, and perform scanning
using an application, such as the supplied
CaptureOnTouch.
• Turn the Auto Start switch ON or OFF before you connect the scanner to a
computer. If it is turned ON or OFF after the scanner is connected to a
computer, the scanner may not operate properly.
• When you use the scanner with the Auto Start switch turned ON, the
computer needs to be started before you connect the scanner to the
computer. If the scanner is connected to a computer that is not started
and the feed tray of the scanner has been opened to turn ON the power,
the computer may not be able to start.
Scanner Operation

Turning the Power ON

1
Open the document feed tray to turn on the scanner's power supply.

When connecting a USB cable and opening the document feed
tray, the start button can slowly flash. After the start button
stops flashing and remains lit, the scanner is ready for use.
Opening the scanner document feed tray switches on the power
supply automatically.
The scanner turns ON, and the Start button lights.
21