Making A Call Using Digit Dialing - Kyocera Cyclops K325 User Manual

Making a call using digit dialing

When using digit dialing, you speak digits to dial a
phone number.
You cannot speak a string of digits. You
Note:
must speak one digit at a time and wait for
the prompt.
From the main screen, press
1.
responds: "Say a name or say Dial."
Say " ". The phone responds: "Speak
2. Dial
a digit."
Speak the first digit of the phone number you
3.
want to call. Once the phone repeats the digit,
you can speak the next digit.
If you pause, the phone prompts you with the
following five options. After the prompt, speak
an option.
– Say " " to erase the last digit entered.
Clear
The phone responds: "Digit cleared."
To clear the entire phone number, say
" " again. When the phone prompts
Clear
you with "Clear entire phone number?",
say " " to clear or "
Yes
– Say " " to dial the number.
Call
– Say " " to cause phone to repeat the
Verify
set of digits that you input.
– Say " " to exit voice recognizer and
Cancel
return to the main screen.
– Speak a digit to enter the next digit. Once
the phone repeats the digit, you can speak
the next digit or pause to hear the prompt.
46
. The phone
" to cancel.
No
Using voice features with
hands-free headset
You can use voice commands to make a phone
call or to answer the phone only if your phone is
connected to a hands-free headset
(sold separately).
The following features apply only to
Note:
hands-free headsets unless noted.
To shop for hands-free headsets, visit
www.virginmobileusa.com
Waking up the phone
If your phone is connected to a hands-free
headset, you can use the voice command to
activate the phone to make a phone call.
To activate the Voice Wake-up setting:
→
Select
1. Menu Settings
→
Voice wake-up
To wake up the phone:
Say " " and listen for a tone.
1. Wake Up
Say " " again until you hear two tones.
2. Wake Up
If the phone does not recognize your
"Wake up" command, see "Training voice
recognition" on page 47.
Answering the phone
You can set your hands-free headset to (1)
answer automatically or (2) answer using a
voice command.
.
→
Call options
.
With accessory
Using Voice Recognition
→