Operation Panel In Standby Mode - MUTOH Spitfire 65 Operation Instructions Manual

6.2 OPERATION PANEL IN STANDBY MODE

This section describes functions operated on the operational panel when the printer is in the normal status.
6.2.1 [F1] – Feeding, Cutting media and Step Adjust
When you want to feed media forward or backward, follow the steps below:
Verify the following regarding the condition of the printer.
Step 1 :
It is not currently printing
I)
Press the [F1] key of the operation panel.
Step 2 :
To shift to the Cut&Feed menu.
I)
Press the [F3] key or the [F4] key on the operation panel.
Step 3 :
The product will perform following operations:
I)
Setup items
Cut & Feed
Notes
If "Take-Up Roll" is set in the media detection setup menu, the product will not operate even if the [F4] key
has been pressed.
6.2.2 [F2] - Cleaning the heads
When there are some missing nozzles, a cleaning should be done. Depending on the quantity of missing
nozzles and which head, a little, normal or powerful cleaning on head 1-2, head 3-4 or ALL could be done.
Verify the following regarding the condition of the printer.
Step 1 :
It is not currently printing
I)
Key name
F1
F2
F3
F4
Operation Instructions Spitfire 65/90 Extreme
Parameters
Cut
Dist.Adj.
Forward
Backward
61
CHAPTER 6 : PRINTER MENU
Description
Cut media
Set step
Feeds media forward.
Feeds media backward.
AP-77140 – Rev. 1.1 – 05/04/07