Sony DCR-VX2000 Service Manual page 73

[MECHANISM DECK SERVICE POSITION-1]
Note: Use the parts only which can be removed easily from outside of the mechanism deck.
Adjustment remote
commander (RM-95)
Cabinet (L) block assembly
[SERVICE POSITION TO CHECK THE VTR SECTION]
Connection to Check the VTR Section
To check the VTR Section, set the VTR to the "forced VTR power ON" mode.
Operate the VTR functions using the adjustment remote commander (with the HOLD switch set in the OFF position)
(However, connect the cabinet (L) assembly when cassette is going to be ejected only.)
Setting the "Forced VTR Power ON" mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 10, set data: 02, and press
the PAUSE button of the adjustment remote
commander.
AC POWER
AC IN
ADAPTOR
CPC-13 jig (J-6082-443-A)
Connect here when the tape path
check is going to be performed.
Mechanism deck
DD-138 board
DC-IN
connector (3P)
(1-794-637-11)
Mechanism deck
Cabinet (L) block assembly
2-6
AC POWER
ADAPTOR
Exiting the "Forced VTR Power ON" mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 10, set data: 00, and press
the PAUSE button of the adjustment remote
commander.
3) Select page: 0, address: 01, and set data: 00.
FP-191 flexible board (60P)
Insert the FP-191 flexible board in the opposite
direction to the normal insertion direction.
VC-242 board
JK-190 board
LANC jack
Adjustment remote
commander (RM-95)
Control switch block (CF-4980) (14P)
(Connect here when cassette is going to be ejected.)
CPC-13 jig
(J-6082-443-A)
AC IN
Monitor TV
VIDEO jack