Yamaha Virago 750 Installation Manual page 8

1. Place your motorcycle on a smooth flat surface, like a garage
floor, and rest it on its center stand.
2. Assemble the axles, tires and wheels, and fenders onto the tow-
pac hitch cart.
3. Carefully align the tow-pac hitch cart's hitch mount with the
receiver hitch on the motorcycle. Now push the hitch mount into
the receiver hitch. (this might be a little difficult until you get use
to doing it. Removing the paint from the hitch mount and applying
a little grease will help.)
4. Place the hitch pin through the receiver hitch and hitch mount
(alignment plate). Install and tighten the tension bolt.
5. Bolt leanstop braces to hitch. (Bolt inserts from the bottom) Be
certain to replace washers/spacers in the same configuration as
when you removed them. see diagram next page
6. Push the motorcycle off of the center stand and risers if used.
7. Check all bolts for tightness.
8. You are now ready for the test ride.
A. Keep your feet up!
B. Ride slowly in first gear until you are comfortable with the
Tow-Pac system.