Table of Contents
Advertisement
OPERATING INSTRUCTIONS
SAFTEY INSTRUCTION FOR MANUAL AND MILLI-VOLT CONTROL WITH PILOT
FOR YOUR SAFETY READ BEFORE LIGHTING
A. This appliance is equipped with an ignition device
which automatically lights the pilot.
B. BEFORE OPERATING smell all around the ap-
pliance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
•
Do not attempt to light any appliance.
•
Do not touch any electric switch; do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
•
If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in, or turn the gas control knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it. Call a qualified service technician. Force or attempted repair may result
in a fire or explosion.
D. Do not use this appliance if any part of it has been under water. Immediately call a qualified service tech-
nician to inspect the appliance and to replace any part of the control system and any gas control that has
been under water.
MANUAL CONTROL LIGHTING INSTRUCTIONS
1. STOP! Read the safety information label.
2. Make sure the manual shutoff valve fully open.
3. This gas log set is equipped with an ignition device (piezo) which automatically lights the pilot. If piezo
ignitor does not light the pilot, refer to instructions for
4. Push in gas control knob slightly and turn clockwise
NOTE: Knob cannot be turned to "OFF" unless knob is pushed
in slightly.
5. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor.
If you smell gas, STOP! Follow "B" in the safety information label. If you don't smell
gas, go to next step.
6. Find pilot - follow metal tube from gas control.
7. From "OFF" position, push in gas control knob slightly and turn counterclockwise
to "PILOT." Push in control knob for 5 seconds.
8. With the control knob pushed in, immediately light the pilot by depressing the piezo
and releasing. Continue to hold the control knob in for about one (1) minute after the
pilot is lit. Release knob and it will pop back up. Pilot should remain lit. If it goes out,
repeat steps 5 through 9.
• If knob does not pop up when released, stop and immediately call your service
technician or gas supplier.
• If the pilot will not stay lit after several tries, turn the gas control knob to off and call
you service technician or gas supplier.
9. Turn gas control knob counterclockwise
1. Push in gas control knob slightly and turn clockwise
18
TO TURN OFF GAS TO APPLIANCE
If you do not follow these instruction
exactly, a fire or explosion may result
causing property damage, personal
injury or loss of life.
Match Lighting Instructions,
"
to "OFF."
to "ON."
to "OFF". Do not force.
page 19.
"
Figure 23 -
Control Knob
Figure 24 -
Manual Pilot
32D1999
Hide quick links:
Advertisement
Table of Contents
