Dell Networking N2000 Series Manual page 13

5 - Display Operational Code Details
9 - Reboot
10 - Restore Configuration to Factory Defaults
11 - Activate Backup Image
12 - Start Password Recovery
Enter choice number 10.
Are sure you want to Erase Current Configuration? (Y/N): Y
Erasing Current Configuration...done.
Boot Main Menu
==============
1 - Start Operational Code
2 - Select Baud Rate
3 - Retrieve Logs
4 - Load New Operational Code
5 - Display Operational Code Details
9 - Reboot
10 - Restore Configuration to Factory Defaults
11 - Activate Backup Image
12 - Start Password Recovery
Enter choice number 9 and the system will reboot. Wait for the following prompt:
Would you like to run the setup wizard (you must answer this question within 60
seconds)? [Y/N] N
Note: All remaining configuration must be done from the switch designated as master. To determine
which switch is the master unit, check the Master LED located on the front of each switch.
13 SCG1015 Dell Networking N2000 Series Configuration Guide