Fujitsu BS2000/OSD User Manual page 35

BS2000 connections
The devices must be attached in the guest system concerned or in the Native BS2000
system (see the "Commands" manual [5]):
/ATTACH-DEVICE UNIT=(<mn1>,<mn2>)<
In addition, the communication devices and the IP addresses must be made known to the
BCAM of the BS2000 system concerned. This is done in the BCAM SOF file (Start Option
File) or also by means of commands at the console (see the "BCAM" manual [4]).
Example of a SOF file
Two redundant lines (
the guest system
/DCOPT HOST=LBSVM1,...
/BCOPTION ARP=QUIET,BROADCAST=ON,ISO9542=OFF,SLOW-POLL=ON
/CREATE-NODE NODE-NAME=HNC#NODE,IP-SUBNET-MASK=255.255.255.128
/CREATE-LINE LINE-NAME=HNCLINE1, IP-ADDRESS=172.25.226.242,-
/ L2-PROTOCOL=*CSMACD(NODE-NAME=HNC#NODE,-
/ WRITE-DEVICE=751C,READ-DEVICE=751D, MAX-LPDU-SIZE=*BY-DEVICE,-
/ SLOW-POLL=*ON,AUTO-ROUTE-SWITCHING=*OFF,ROUTE-RESWITCHING=*OFF)
/ CREATE-LINE LINE-NAME=HNCLINE2, IP-ADDRESS=172.25.226.252,-
/ L2-PROTOCOL=*CSMACD(NODE-NAME=HNC#NODE,-
/ WRITE-DEVICE=711C,READ-DEVICE=711D, MAX-LPDU-SIZE=*BY-DEVICE,-
/ SLOW-POLL=*ON,AUTO-ROUTE-SWITCHING=*OFF,ROUTE-RESWITCHING=*OFF)
/ACTIVATE-LINE LINE-NAME=HNCLINE1
/ACTIVATE-LINE LINE-NAME=HNCLINE2
/CREATE-PROCESSOR PROC-NAME=LBSVM2,MAX-TSDU-SIZE=65530
/CREATE-ROUTE ROUTE-NAME=ROUVM2,PROC-NAME=LBSVM2,PATH=*NODE(-
/ NODE-NAME=HNC#NODE,LINE-NAME=HNCLINE1,L3-PROTOCOL=*IP(-
/ IP-ADDR=172.25.226.240)),ATTR=*PAR(ROUTE-SEQUENCE-NUM=1)
/MODIFY-LINE LINE-NAME=HNCLINE1,-
/ AUTO-ROUTE-SWITCHING=*ON,ROUTE-RESWITCHING=*ON
/MODIFY-LINE LINE-NAME=HNCLINE2,-
/ AUTO-ROUTE-SWITCHING=*ON,ROUTE-RESWITCHING=*ON
/BCACT NODE=HNC#NODE,ACT=ONLY
/BCACT PROCESSOR=LBSVM2,ACT=ALL
...
U41655-J-Z125-5-74
and
HNCLINE1 HNCLINE2
.
LBSVM1
) and the guest system are defined in
LBSVM2
35