How To Use; Operating The Dryer - LG DLEX3570 Series Owner's Manual

HOWTO usz 31
HOW TO USE
Operafing the Dryer
Filter
CLEAN THE LiNT FILTER
If the lint filter has not already been cleaned, lift out the filter and remove tile
lint from the last load. This will help ensure the fastest and most efficient drying
performance.
LOAD THE DRYER
Load the dryer with tile wet laundry from tile washer. If the load is extra large,
you may need to divide it into smaller loads for proper performance and fabric
ca re.
TURN ON THE DRYER
Press tile POWER button to turn on the dryer. Tile cycle LEDs will illuminate
and a signal will sound, if turned on. Refer to page 10.
SELECT A CYCLE
Turn tile cycle selector knob either direction until the LED for tile desired cycle
is on. The preset temperature, dry level, and option settings for that cycle will
be shown. Refer to page 32. Default settings for the selected cycle can now be
changed if desired. This can be done using the cycle modifier buttons as shown
on page 34. Cycle options can be added using the option buttons as shown on
page 34-35.
'- @ NOTE --,
Not all options or modifiers are available on all cycles. A different chime will J
sound and the LED will not come on if the selection is not allowed.
BEGIN CYCLE
Press the START/PAUSE button to begin the cycle. The cycle can be paused at
any time either by opening the door or by pressing the START/PAUSE button. If
the cycle is not restarted within 4 minutes, the dryer will shut off and the cycle
settings will be lost.
END OF CYCLE
When the cycle is finished, the chime will sound if it is set. Remove your
clothing from the dryer immediately to reduce wrinkling. If WRINKLE CARE
is selected, the dryer will tumble briefly every few minutes to help prevent
wrinkles from setting in the clothes.