Crankcase Cover; General Assembly - Generac Power Systems GTV99O Service Manual

SECTION 13: ENGINE ASSEMBLy
)
TORQUE SEQUENCE FOR
CRANKCASE COVER :
1-2-3-4-s-6-7-8-9-10
Figwe 13-7
GENERALASSEMBLY
l. Install alternator, Figurc 13-8.
a. Torque screws to 12.2 Nm (9 ft. lbs.).
Figurc t3-8, tnstall Alternatol
2. Innall back plate.
a. Torque screws to l0 Nm (7.4 ft. lbs.)
3. Install stader motor.
a.Torque screws to 24.4 Nm (18 ft. lbs.).
Impottant: Route altenator whes through rctief in back
plate. DO NOT pinch whes,
a. As,Fmble ion ion co ls ro engine, Figure.3-i.
a.l\,,lounting holes in coil are slotted. push coit away from
. fly!,r'heelas
faras possible and tighten one screw to hotd
coilin place.
5. Repeai for second coil.
Note: The side shown in Figurc 13-9 must face up on both
coils ot the engine will not fundion Noperly
6. lnsta I ground wire onto tab terminal on ignition coils.
lmportant : Make surc wircs arc routed over coil mount-
ing pos6.
INSTAI.t BREATHER
1. InseJt breather material.
2. Instal breather assembly and gasket.
3. Torque boltsro 6.8 Nm (5 fr. tbs )
INSTAIL FIYWHEEL
lmportant: Clean flwheel and cankshalt taper rcmov_
ing alloil, ditt or qrcase,
I nsert flywheel key into crankshaft.
2. Assemble flylvheel to crankshaft.
3. hstal washerand fly.vvheelnut.
4. Toqueflywhee nutto 204Nm (150ft. bs.),Fgure13_jO.
Figut€ l3-9. lnstall coils