Generac Power Systems GTV99O Service Manual page 34

SECTION 5: CYUNDER HEAO AND VALVES
STATIC GOVERNOR ADJUSTMENT
1. with governor lever clinching screw loose, push on gov-
ernor lever until throttle is wide open, Do not bend governor
link or distort governor lever.
2. Rotate governor arm clockwise as far it will go (Figure
s-20).
a.Toque clinching sc€w to 11.6 Nm (100 in. lbs)-
3. Checkto make sure that the throltle travelsfrom "WOT"
to "IDLE." lf it doesnt, the governor will need to be rcset
again.
4. lnstall throttle and choke control cables and check for
proper operation.
6. lnstallrotatingscrcen.
a. Torque screws to 1.9 Nm (17 in. Tbs).
7. Install finger guard-
a. lf engine is equipped with socket head screws, torque
screws to 4.5 Nm (40 in. lbs).
b.lf engine is equipped with finger screws, tighten screvls
by hand to approximately
1.3 Nm (12 in. lbs.).
8. Assemble aircleanet
WARNINGT Before starting or running engine, static
adjustment o{ the governor must be completedl
Failure to mak€ th€ static adjustments first could
nesult in engine oversp€eding whi6 may result in
engine damage, property danage or personal injury
Figwe 5'20. Static Govetnot Adjustment
Figve ,19. Genenl attenbly
5.6