Mount The Switchplate - KVH Industries TracVisionM7 Installation Manual

Mount the Switchplate

11
In Step 3, you identified a suitable mounting
location for the switchplate and cut out the
mounting hole in the mounting surface. Now
follow these steps to mount the switchplate.
a. Fit the switchplate assembly into the
mounting hole until it is flush with the
mounting surface.
b. Drill four 5/32" (4 mm) holes in the
countersunk settings in the switchplate's
support frame (see Figure 21).
c. Secure the support frame and switchplate
assembly to the mounting surface using four
#6 screws.
d. Snap the front cover onto the switchplate to
conceal the mounting screws and support
frame.
Figure 21: Mounting the Switchplate
Switchplate
Mounting Surface
5/32" ( 4 mm)
Mounting Hole (x4)
#6 Screw (x4)
Front Cover
13