Mount The Antenna(S) - KVH Industries TracVision HD11 Installation Manual

9

Mount the Antenna(s)

Follow the steps below to mount the antenna to
the mounting surface.
a. Using a 7/16" socket/ratchet or nut driver,
unlock the three hex latches securing each of
the antenna's service hatches (see Figure 16
on page 15). Then gently lower the hatches.
b. Orient the antenna so the antenna forward
arrow is facing the bow, stern, port, or
starboard (see Figure 22).
c. Using the Installation Worksheet, record the
antenna's mounting orientation.
NOTE: If you are installing two antennas, mount the
antennas facing opposite directions (180° offset).
d. Carefully lower the antenna using the foam
seals and mounting holes as guides. While
lowering the antenna, adjust the cables as
necessary to maintain an adequate service
loop, approximately 8" (20 cm) of slack.
IMPORTANT!
To prevent damage to the foam seal, do not
reposition the antenna laterally once the
antenna's foam seal has made contact. If you
need to reposition the antenna, lift the
antenna vertically first.
e. Guide the antenna downward and ensure the
mounting holes and foam seals are aligned.
WARNING
Observe the safety warnings printed on the
supplied tube of Loctite
"Contains mineral oil, calcium hydroxide,
and copper. May cause skin, eye, and
respiratory irritation. Wear eye protection
and gloves. First aid: In case of eye or skin
contact, flush with water. Obtain medical
attention for any eye or internal contact."
f. Apply a thin layer of anti-seize lubricant to
the threads of the four supplied 1/2"-13
mounting bolts to prevent galling.
®
anti-seize lubricant:
Figure 22 Antenna Forward
Antenna - Top View
Cable Connectors FWD Arrow Inside
(Antenna Rear)
Radome (Face
Vessel's Bow, Stern,
Port, or Starboard)
17