Removing A Hard Disk - Fujitsu CELSIUS W510 Operating Manual

System expansions
► Slide the hard disk drive with the EasyChange rails into the drive cage in the direction of the
arrow (1). Ensure that the label on the 3½" hard disk drive is facing the side cover to be opened.
If you are installing a 2½" hard disk drive, ensure that the label is on the top.
► Connect the cables to the hard disk drive.
► Reattach the protective grille (see
► Reattach the hard disk front panel to the casing (see
hard disk front panel", Page
► Close the casing (see
It may be necessary to modify the entry for the drive in the BIOS Setup.

Removing a hard disk

The principles for installing/removing hard disks for the device as described below are identical
for all types of hard disk. Only the size and alignment of the hard disk in the casing may
vary (install either horizontally or vertically depending on the hard disk type).
The following images illustrate the installation of a 3
Removing the hard disk drive
► Open the casing (see
► Remove the hard disk front panel (see
► Remove the protective grille (see
► Disconnect the cables connected to the hard disk drive.
54
"Securing the protective grille", Page
56).
"Closing the casing", Page
"Opening the casing", Page
"Removing the hard disk front panel", Page
"Removing the protective grille", Page
1
"Securing the
36).
/ " drive.
1
2
35).
Fujitsu Technology Solutions
56).
52).
53).