Time And Date Settings - Bosch DSA-N2B20 Installation Instructions Manual

14 en | Configuration through the Web Interface
7.
8.
9.
10. Click Apply to confirm the changes. As this reconfigures the network interface you are
11. Reset the network settings of your computer to its original settings or settings suitable
12. Reconnect to the FilerView interface using the new IP address of the storage system.
13. On the FilerView start page click the FilerView icon to open the administration interface
6.2

Time and Date Settings

1.
2.
3.
4.
- | V2 | 2009.11
Click Modify next to the network interface labeled e0a and configured with IP address
10.10.10.10.
Enter the IP address information for the network. Change IP Address and Netmask to
the desired value. Leave Broadcast blank.
Example screen:
Set Media Type to 10/100/1000 Mbit Auto-negotiate.
Leave the Trusted option enabled.
connected to, the page will fail to load after clicking the Apply button.
for your CCTV network.
Enter http://<newIPaddress>/na_admin and log in using root as the user name and
leaving the password blank.
again.
In the navigation panel, select Filer > Set Date/Time.
The current date and time are displayed. If the time settings are incorrect, click Modify
Date/Time. This starts the Date/Time Wizard. While the wizard guides you through the
set-up, click Next to go to the next step. Click Cancel, if you do not want to continue the
procedure.
From the list, select the System Time Zone. Click Next.
Set System Time Update Method to Manual. Click Next.
Enter the current time and date. Click Next.
Installation Guide
DSDA Digital Storage Disk Arrays
Bosch Sicherheitssysteme GmbH