Table of Contents
Advertisement
DSDA Digital Storage Disk Arrays
6
Configuration through the Web Interface
Follow these steps to configure each system. This procedure is nearly identical for all three
types of storage systems.
NOTICE!
It can take a few seconds until the LEDs on your system power supplies light up.
NOTICE!
Java Runtime Environment must be installed on your computer to use the Web interface.
Always use the most recent version.
NOTICE!
If you are using the VRM Video Recording Manager application (Version 1.5 or higher), use
VRM Configurator for the configuration steps described in Section 6.3 Configuring the Volume -
Section 6.5 Creating LUNs. Configure only the IP address and the date/time settings from
within the Web interface of the device (see Section 6.1 Configuration of the Network Settings
and Access to the Interface - Section 6.2 Time and Date Settings).
If you use the digital storage systems for direct recording, perform all configuration steps from
within the Web interface of the device.
6.1
Configuration of the Network Settings and Access to the
Interface
All systems are delivered with a default IP address configuration of 10.10.10.10, subnet mask
255.0.0.0. To connect to the system, configure a network interface on your computer to use
the same network.
Bosch Sicherheitssysteme GmbH
Turn on the system.
DSA-N2B20 / DSA-N2B40 / DSA-N2B50 / additional disk shelves: There is a power
switch on each power supply unit (right- and left-hand side) on the rear side of the
device.
If there are additional disk shelves installed, first power on the base unit, then power on
the expansion units.
Installation Guide
Configuration through the Web Interface | en
11
- | V2 | 2009.11
Advertisement
Table of Contents
