Rear Handles And Ajv Cushions - Shindaiwa 300 Service Manual

Rear Handles and A-V Cushions
Section
12
Reassembly
STEP 5. Replace all mau nling screws and
(continue d)
limi ter bolts in the reve rse arder 01 removal .
• Screws in slalled in ny lon handles shou ld be
in sta lled "dry" and Ihen tightened lirmly by
han pressure alone
• Screws inslalled in diecast handles (ob so­
lete) should be precoate d wllh Th reeBond
1401
screw locking agent an d then firmly
ti ghtened by hand.
STEP 6. For saw Models 575, 680 , an d 695
using diecas t rear handle s, final-lighlen all
five A-V cush ion sc rews lo 55 In/l b
(65 kg/cm )
STEP 7. Use a few drops 01 grease or li ght oi l
lo lubricale lhe edges 01 each dust cap ,
and Ihen reinstall the dusl caps in the
rever se order of removal.
Bool Sleeve
IMPORTANT!
Bool
(Sealing Ring)
A blunled scre dri er!ip can ald in dust
c ap in stallation.
STEP 8. Replace the fro
t
hand le and Ihen
install and fl rml y tlghle n all mounling
sc rew s.
o
ArrENTION!
Use of ove r-Ienglh mo ntlng sc rew s can
punctu re the f el tank or engi ne cran k­
casel For c orreel screw si ze , always
con s It the apprapriale IP L lar he saw
Bool
be in g ser vl ced.
Figure 127 Typ ical Bool Slee ve Installation
STEP 9. Connec t the stop switch and then
reins all lhe boa! sleeve (where used ,
Fig ure 127), carbu re tor, an cleaner, and
cylln der cover In Ihe re verse orde r 01
rem oval
STEP 10.
Install the bar, chain , and clulch
ca er in lhe reverse arder al remaval.
é
Shlndal\'la Inc 1995
11 7