Ford TOURNEO COURIER Owner's Manual page 170

Warning lamp
Solid warning lamp
Flashing warning
lamp
Tire Pressure Monitoring System
Reset Procedure
Overview
You must carry out the system reset
procedure after each tire replacement or
adjustment of the tire pressures.
Tourneo Courier/Transit Courier (C4A) Vehicles Built From: 19-06-2014, M1 Kombi/M1 Kombi Van/N1 Kombi/N1 Kombi Van/Van, ET7J-19A321-AKB (CG3621en) enGBR, Edition date: 04/2014, First P
Wheels and Tires
Description
Tire(s) under-inflated
Spare tire in use
Tire pressure monitoring
system malfunction
Spare tire in use
Tire pressure monitoring
system malfunction
1. Make sure tires are at the correct
pressure. See Wheels and Tires
(page 161). The tire pressures are also
on the tire inflation pressure label
(located on the edge of driver door
or the B-Pillar).
2. After inflating the tires to the correct
pressure you must carry out the tire
pressure monitoring system reset
procedure. See Tire Pressure
Monitoring System Reset
Procedure in this chapter.
Repair the damaged road wheel and tire
and refit the repaired road wheel and tire
assembly to your vehicle to restore the
correct operation of the system.
If the tires are correctly inflated and the
spare tire is not in use but the light
remains on, the system has detected a
fault that requires service.
Repair the damaged road wheel and tire
and refit the repaired road wheel and tire
assembly to your vehicle to restore the
correct operation of the system.
If the tires are correctly inflated and the
spare tire is not in use but the light
remains on, the system has detected a
fault that requires service.
To maintain your vehicle load carrying
capability, your vehicle requires different
tire pressures in the front tires compared
to the rear tires.
The system illuminates the warning lamp
at different pressures for the front and rear
tires.
168
Action