Panasonic CF-17 Operating Instructions Manual page 3

For U.S.A.
Federal Communications Commission Radio
Frequency Interference Statement
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the Panasonic Service Center or an experienced ra-
dio/TV technician for help.
Warning
To assure continued compliance, use only shielded interface
cables when connecting to a computer or peripheral. Also, any
changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Responsible Party: Matsushita Electric Corporation of America
One Panasonic Way
Secaucus, NJ 07094
Tel No:1-800-LAPTOP-5 (1-800-527-8675)
FCC Regulation Notice for modem
This equipment contains a FCC approved modem.
Manufacturer of modem: Xircom
Model No. MPCI1B-56G
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
1. This equipment complies with Part 68 of the FCC rules. On the com-
puter is a label that contains, among other information, the FCC reg-
istration number and ringer equivalence number(REN)for this equip-
ment. If required, this information must be provided to the telephone
company.
2. An FCC compliant telephone cord and modular plug is provided
with this equipment. This equipment is designed to be connected to
the telephone network or premises wiring using a compatible modu-
lar jack which is Part 68 compliant. See Installation Instructions for
details.
3. The REN is used to determine the quantity of devices which may be
connected to the telephone line. Excessive RENs on the telephone line
may result in the devices not ringing in response to an incoming call. In
most, but not all area, the sum of RENs should not exceed five (5.0). To
be certain of the number of devices that may be connected to a line, as
determined by the total RENs, contact the local telephone company.
4. If your telephone equipment cause harm to the telephone network, the
telephone company will notify you in advice that temporary discontinu-
ance of service may be required. But if advice notice isn't practical, the
telephone company will notify the customer as soon as possible. Also,
you will be advised of your right to file a complaint with the FCC if you
believe it is necessary.
5. The telephone company may take changes in it's facilities, equip-
ment, operations or procedures that could affect the operation of the
equipment. If this happens the telephone company will provide ad-
vance notice in order for you to make necessary modifications to
maintain uninterrupted service.
6. If trouble is experienced with this equipment, for repair or warranty
information, please contact Matsushita Electric
Corporation of America, toll free at 1-800-LAPTOP5 (1-800-527-
8675). If the equipment is causing harm to the telephone network, the
telephone company may request that you disconnect the equipment
until the problem is resolved.
7. There are no user serviceable parts contained in this equipment.
8. This equipment may not be used on coin service provided by the
telephone company. Connection to party lines is subject to state tar-
iffs.
9. The Telephone Consumer Protection Act of 1991 makes it unlawful for
any person to use a computer or other electronic device to send any mes-
sage via a telephone fax machine unless such message clearly contains in
a margin at the top or bottom of each transmitted page or on the first page
of the transmission, the date and time it is sent and an identification of the
business or other entry, or other individual sending the message and the
telephone number of the sending machine or such business, other entity,
or individual. In order to program this information into your fax software,
you should refer to the manual of the Fax software being used.
"Caution : To reduce the risk of fire, use only No.26 AWG or larger telecom-
munication line cord."
"ATTENTION : Pour réduire le risque d'incendie, utiliser uniquement des
conducteurs de télécommunications 26 AWG ou de section supérieure."
3