Cycle Selection Chart; Rinse & Hold; Plate Warmer - GE GSD1230 Use & Care Manual

Dial Cycles
(continued)
The RINSE & HOLD cycle is for rinsing
partial loads which will be washed later.
Do not use detergent.
a. Make sure ENERGY SAVER is selected.
b. Be sure the door is unlatched.
c. Slowly turn the Cycle Indicator Dial to
RINSE & HOLD.
d. Latch the door to start the cycle.

Cycle Selection Chart

Water Use
Gallons
(approx.)
Wash Cycles
10.6
POTSCRUBBER
NORMAL WASH 9.1
LIGHT WASH 7.9
WATER SAVER 6.4
SHORT WASH 7.4
RINSE & HOLD 3.0
*Unextended times. These cycle times will be increased approximately 21 minutes if TEMP BOOST option is selected.
Drying Options:
HEATED DRY. Available on all wash cycles except RINSE & HOLD. Add 32 minutes to wash cycle time.
ENERGY SAVER. Drying heater is turned off. Dishes dry naturally.
CYCLE
ON
Wash Cycle
Time
Minutes
(approx.)
72*
Rinse Rinse
51*
Rinse
51*
51*
43*
12*
START
SHORT WASH
START DELAY
(HRS)
OFF
PLATE
WARMER
(PRESS
HEATED DRY)
RINSE & HOLD
The PLATE WARMER cycle is for warming clean
dishes and serving plates for the serving of hot foods.
The cycle will take approximately 32 minutes if selected.
a. Load clean plates and dishes to be warmed.
b. Select HEATED DRY.
c. Be sure the door is unlatched.
d. Slowly turn the Cycle Indicator Dial to

PLATE WARMER.

e. Latch the door to start the cycle.
Cycle Sequence
Main
Rinse Rinse
Wash
Main
Rinse Rinse
Wash
Main
Rinse Rinse
Wash
Main
Rinse
Wash
Main
Rinse Rinse
Wash
Quiet Power
Rinse Rinse
Rinse Rinse
Rinse
Rinse
Rinse Rinse
Rinse Rinse
Rinse
Rinse
5