Cycle Selection Chart - GE GSD1200 Use And Care Manual

I
Dial Cycles
(continued)
The RINSE & HOLD cycle is for rinsing
partial loads which will be washed later. Do
a. Make sure HEATED DRY is off.
b. Be sure the door is unlatched.
c. Slowly turn the Cycle Indicator Dial to
RINSE & HOLD.
d. Press the OPTIONS RESET button. This
turns all Energy Options off.
e. Latch the door to start the cycle.

Cycle Selection Chart

Wash Cycles
POTSCRUBBER
NORMAL WASH
LIGHT WASH
WATER SAVER
SHORT WASH
RINSE & HOLD
Unextended t]nles. "1'hese cycle t!mes WIII be increased approximately 21 minutes if Wash Heat Boost option is selected
Drying Options;
HEATED DRY
on. Available on all wash cycles except RINSE & HOLD. Add 32 minutes to wash cycle titne
HEATED DRY off, Drying heater is turned off, Dishes dry naturally,
Wash Cycle
Water Use Time
Gallons Minutes
10.6 72
7.9
6.4
START ------
START
OFF ':
WARMER
(PRESS HEATEO DRYI
The PLATE WARMER cycle is for warming clean
dishes and serving plates for the serving of hot foods.
The cycle will t~-e-approximately 32 ;inutes if selected.
a. Load clean plates and dishes to be warmed.
b. Select HEATED DRY on.
c. Be sure the door is unlatched.
d. Slowly turn the Cycle Indicator
PLATE WARMER.
e. Latch the door to start the cycle.
Cycle Sequence
SHORT WASH
Quiet Power
I
5