Remote Control - Krell Industries Preamplifier KRC 2 Owner's Reference Manual

G. REMOTE CONTROL
1. When a function button on the remote control is
~ssed, the blue pilot LED will flash on the KRC-2.
en the button is released the flashing stops.
2. The functions of the remote control are described
below:
UP arrow
DOWN arrow
volume higher
volume lower
S 1 selects S 1 input
$2 selects $2 input
$3 selects $3 input
$4 selects $4 input
B 1 selects B 1 input
B2 selects B2 input
TAPE selects Tape input and allows tape
monitoring
PHASE 0 or 180 degrees
LED illuminates when the phase is
reversed 180 degrees
GAIN Low 6 dB High 12 dB
LED illuminates in high position
MUTE
BALANCE <
BALANCE >
No signal output with LED on
Left channel attenuation in 1 dB
increments and OFF
Right channel attenuation in 1 dB
increments and OFF
BATTERY INSTALLATION
NOTE: Batteries should be replaced when the KRC-2
functions from the remote control are not readily
accessible.
1. Remove the four hex head screws from the bottom
12ortion of the remote control's front plate.
2. llemove the back plate to expose the battery storage
compartment.
3. Insert batteries (Refer. to the polarity drawing while
inserting the batteries)
4. Replace the back plate and insert the four hex head
screws.
11