Chassis
Bracket
- Removing the Control Unit (Fig.7)
1. Unbend the tabs at two locations indicated by arrows until straight.
2. Remove the screw F.
3. Disconnect the two connectors, and then remove the Control Unit.
- Removing the Mechanism Unit (Fig.7)
1. Remove the five screws G, and then remove the four Holders and four Dampers.
2. Remove the two springs A, spring B spring C, and four tubes from the hook.
3. Remove the Mechanism Unit from the Chassis.
Holder
G
Damper
Case
Fig.5
Damper
G
Holder
A
Tube
Tube
Chassis
FX-MG8517ZT,MG8817ZT
B
Tube
Mechanism Unit
C
Tube
A
G
Holder
Damper
Fig.6
F
Control Unit
Damper
G
Holder
G
Fig.7
93