Install The Stones And Lava Rock - Heatilator ECLIPSE-32 Installation Manual

D. Install the Stones and Lava Rock
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation.
WARNING! Choking Hazard! Keep stones and lava
rock out of reach of children.
INSTALLATION:
1. Ensure rock placement jig is in place before beginning
placement of stones.
installed. The number of pins will vary depending on
the model. Use a Phillips screwdriver. Figure 11.2
shows location of pins and jig.
LOG LOCATING PINS (CIRCLED)
ROCK PLACEMENT JIG
Figure 11.2. Location of Pins and Jig
2. Place a thin layer of lava rock on the base pan. Do
NOT place on burner top. See Figure 11.3.
WARNING! Risk of Explosion! DO NOT place lava rock
on burner top. Improperly placed lava rock interferes with
proper burner operation.
Figure 11.3. Lava Rock Placed on Base Pan.
Remove log locating pins if
Heatilator • ECLIPSE-32, ECLIPSE-36 Installation Manual • 2297-984 Rev. B • 6/15
3. Place stones on the base pan in a random manner as
shown in Figure 11.4. DO NOT place rocks on the rock
placement jig. You may have extra stones depending
on the look desired.
WARNING
FLANGE
RISK OF EXPLOSION!
• Place stones according to instructions.
• Do NOT place stones on burner top.
• Do NOT place stones in a position that they may fall into
area in front of pilot.
• Do NOT use more than 30 stones per fi replace.
• Do NOT stack stones. Place in single layer.
• Use ONLY Hearth & Home Technologies-approved
optional media with this appliance.
Improperly placed stones interfere with proper burner
operation.
Delayed ignition may occur.
Figure 11.4. Stones Placed on Base Pan.
4. Remove rock placement jig. Ensure that the stones
are approximately 1/4 inch from the burner tube slot.
Figure 11.5. Stones in Place.
47