Table of Contents
Advertisement
INSTALLATION
14
Installing Logs
INSTALLATION
Continued
INSTALLING LOGS
CAUTION: Do not remove the warning and in-
struction labels attached to the heater base assem-
bly. These markings contain important warranty and
safety information.
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
WARNING: After installation and periodically there-
after, check to ensure that no flame comes in contact
with any log. With the heater set to High, check to see
if flames contact any log. If so, reposition logs accord-
ing to the log installation instructions in this manual.
Flames contacting logs will create soot.
It is very important to install the logs exactly as instructed. Do not
modify logs. Only use logs supplied with heater.
1. Place one-piece log set on grate to fit as illustrated in Figure 24.
Make sure middle section at bottom of log set is seated into
"U"-shaped cutout in center of chassis (see Figure 25).
IMPORTANT: Make sure log does not cover any burner ports.
Chassis
Figure 24 - Installing One Piece Log Set
For more information, visit www.desatech.com
For more information, visit www.desatech.com
2. Install fireplace insert screen by slipping notches of fireplace
insert screen over screws on front of fireplace insert (see Fig-
ure 26).
WARNING: You must operate this fireplace in-
sert with the fireplace insert screen in place. Make
sure fireplace insert screen is in place before run-
ning fireplace insert.
Figure 25 - Installing One Piece Log Set (Top View)
One Piece
Log Set
Middle Section
at Bottom of
Log Set
Figure 26 - Installing Fireplace Insert Screen
Burner
"U"-shaped
Cutout in
Chassis
One Piece Log Set
Burner
Ports
Notches
Screws for
Mounting
Screen
111285-01A
Advertisement
Table of Contents
