Remote Control Operation - Dimplex Cadiz eco CDE2T Operating Instructions Manual

REMOTE CONTROL OPERATION

see Fig. 14
(CDE2ECC & CDE3ECC models only)
The batteries for the remote control are not installed in the
remote but are packed separately in the carton. To install
batteries please follow diagrams behind battery cover on
the remote control.
The remote allows the set temperature to be adjusted,
the mode to be selected or can be used to put the heater
in FROST Protection mode.
Full Heat output can only be achieved when using the
remote control i.e. both Left hand and Right hand panels
are on.
Press the ' ' button on the Remote Control to go from
OFF, Man On High and back to OFF again. Press the '
' or ' ' buttons on the remote to set desired temperature
between 5 C and 35 C. Press the ' ' button to put the
o o
heater into FROST Protection mode. Pressing the ' '
button (on the Remote Control) is the only way (using the
Remote Control) to bring the heater out of this mode i.e.
pressing the ' ' or ' ' buttons on the remote will have no
effect on the heater.
Safety Overheat Protection
For your safety this appliance is fitted with a thermal
cut-out. In the event that the product overheats for some
reason, the cut-out prevents excessive temperatures on
the product by cutting the power to the heater. Once the
heater has cooled down, it will reset automatically, it will
continue to cycle on and off automatically until the reason
for overheating is removed.