Table of Contents
Advertisement
CDE2T, CDE2TI, CDE3TIE CDE2ECC & CDE3ECC
08/50580/4
Issue 4
The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC)
EN55014, EN60555-2, EN60555-3. These cover the essential requirements of EEC Directives 2006/95/EC and 2004/108/EC.
Advertisement
Table of Contents
Related Manuals for Dimplex Cadiz eco CDE2T
Summary of Contents for Dimplex Cadiz eco CDE2T
- Page 1 CDE2T, CDE2TI, CDE3TIE CDE2ECC & CDE3ECC 08/50580/4 Issue 4 The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC) EN55014, EN60555-2, EN60555-3. These cover the essential requirements of EEC Directives 2006/95/EC and 2004/108/EC.
- Page 2 13 : 17 CDE2T (Fig.2) CDE2Ti CDE2ECC & CDE3ECC (Fig.4) CDE3Tie (Fig.3) 13 : 17 ADVANCE AUTO (CDE2T/Ti) (CDE3Tie) 13 : 17...
-
Page 3: Important Safety Advice
Dimplex Cadiz Eco Models : CDE2T, CDE2TI, CDE3TIE CDE2ECC & CDE3ECC THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE Model Description Watts given supervision or instruction concerning the use of the appliance in a safe way and CDE2T Standard Model Switch &... - Page 4 ELECTRICAL CONTROLS WARNING: THIS APPLIANCE MUST BE EARTHED Thermostat The use of an extension lead or multi-plug adaptor is (CDE2T, CDE2TI & CDE3TIE models only) not advised when connecting this product to the mains. The Thermostat (see ‘T’ in Fig.’s 2 & 3) controls the heat Connection through these devices could lead to a risk of output according to the room temperature.
- Page 5 DIGITAL TIMER OPERATION The Advance Function (see ‘z’ in Fig. 3 & Fig. 5) When in ‘AUTO’ MODE, if the ‘+’ button is pressed for longer than 2 seconds the programme will ADVANCE to (CDE2TI & CDE3TIE models only) the next setting programmed and will only revert back IMPORTANT: Remember to observe all safety warnings to the program when the subsequent programme time when operating the heater on auto setting, either attended...
-
Page 6: Electronic Climate Control
ELECTRONIC CLIMATE CONTROL Setting the Timer Programs see Fig. 4 Two program settings are possible, P1 and P2. Only high (CDE2ECC & CDE3ECC models only) heat is possible for program settings. Press ‘ ’ once to set the programs, starting with P1 AUTO ON – See Fig 10. Operation 1. -
Page 7: Remote Control Operation
REMOTE CONTROL OPERATION see Fig. 14 (CDE2ECC & CDE3ECC models only) The batteries for the remote control are not installed in the remote but are packed separately in the carton. To install batteries please follow diagrams behind battery cover on the remote control. - Page 8 Be careful not to allow moisture in to the heater. [c] Glen Dimplex UK Limited All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex UK Limited.