Kenwood TS-590S Setting Manual page 26

Operations Cannot exchange the audio
transmission correctly between the
remote station and the host station.
The audio transmission keeps
varying in volume and is not
constant.
The final part of the audio
transmitted from the host station
transceiver is missing.
When selecting a tuning step other
than "Preset", reaction may be
delayed during KNS operations.
Comprehe I'm using comprehensive security
nsive software, but when I try a KNS
security connection, the warning "Software
software, is attempting to connect to the
etc. internet" is displayed. Can I press
the "Block" button?
Question
25
Answer
Refer to the ARVP-10 help, and check
the settings.
Check that a default device has been
specified for the PC speakers,
microphone, or headset currently in
use, using the Windows sound settings
on the remote station PC.
Check whether the PC microphone or
headset has been muted or is at low
volume.
Check that the PC, speakers,
microphone, and headset are
connected correctly.
Has the AGC been turned ON using the
VoIP software input audio settings?
For details, refer to the VoIP software
user's manual, and check the settings.
If you return to receiving operations
immediately after the conversation has
finished using the remote station, you
may switch to receiving before all the
audio has been transmitted due to the
audio transmission delay.
In such cases, use the ARCP-590
pulldown menu to select "Tool" and then
"Setup TX Control", and set a slightly
longer time in "Delay at TX changes to
RX when Network Connection".
When set to other than "Preset", the
network is more easily delayed than when
using "Preset" due to the difference in the
internal commands. In such cases, either
select "Preset" and perform tuning, or
change the frequency using the
"MULTI/CH" operation.
Refer to the user's manual for the
comprehensive security software being
used, and set it so that the
communications of the port used by
ARCP-590, ARHP-590 and ARVP-10
are not blocked.