Advertisement
I. PC and Controller connections
1. Connect EVLED VSC controller to the graphics card on the PC with the included DVI cable. Connect EVLED VSC RJ11 port to the RS232
port on the PC with the included RS232 signal cable as pictured below. If your PC does not include RS232, use the included RS232 to
USB convertor.
2. On your PC, set up a secondary or clone display. A flashing green LED on the rear of the EVLED VSC indicates successful
communication.
EVLED VSC Controller
Connect the RS232 data cable into your PC (Use the RS232 to USB convertor if you
don't have RS232 on your PC). Connect RJ11 end into the EVLED-VSC.
One end of DVI cable connects with sending card in EVLED VSC controller
ELATION
The other end of DVI cable connects with PC graphic card
Advertisement
