Advertisement

Quick Links

TVL1000
User Instructions
Rev. 2/13
TVL1000
Unpacking:
Thank you for purchasing the TVL1000 by Elation Pro-
fessionals
. Every TVL1000 has been thoroughly tested and has been
®
shipped in perfect operating condition. Carefully check the shipping
carton for damage that may have occurred during shipping. If the
carton appears to be damaged, carefully inspect your fixture for any
damage and be sure all equipment necessary to operate the unit has
arrived intact. In the event damage has been found or parts are miss-
ing, please contact our toll free customer support number for further
instructions. Please do not return this unit to your dealer without con-
tacting customer support first.
Introduction:
The TVL1000 DMX intelligent LED fixture. The TVL1000
has 3 DMX Modes; Two 2 Channel Modes, and a 3 Channel Mode. The
fixture has two operating modes; manual mode or DMX controlled.
The TVL1000 can only be run as stand alone unit. This unit is suitable
for theaters, studios, retail stores, and other similar locations. For best
results use fog or special effects smoke to enhance the light projec-
tions.
Customer Support:
Elation Professionals
tomer support line, to provide help and to answer any question should
you encounter problems during your set up or initial operation. You
may also visit us on the web at www.elationlighting.com for any com-
ments or suggestions. Service Hours are Monday through Friday 8:00
a.m. to 4:30 p.m. Pacific Standard Time.
Voice:
(323) 582-3322
Fax:
(323) 832-9142
E-mail:
support@elationlighting.com
To purchase parts online visit http://parts.elationlighting.com
Warning!
To prevent or reduce the risk of electrical shock or fire, do
not expose this unit to rain or moisture.
Warning!
This may cause severe eye damage. Avoid looking directly
into the light source at all times!
©Elation Pr
fessionals® - www.elationlighting.com - TVL1000 Instruction Manual Page 2
o
General Information
provides a toll free cus-
®

Advertisement

Table of Contents
loading

Summary of Contents for Elation TVL1000

  • Page 1 3 DMX Modes; Two 2 Channel Modes, and a 3 Channel Mode. The fixture has two operating modes; manual mode or DMX controlled. The TVL1000 can only be run as stand alone unit. This unit is suitable for theaters, studios, retail stores, and other similar locations. For best results use fog or special effects smoke to enhance the light projec- tions.
  • Page 2: General Instructions

    Warranty Registration shock and fire in case of an internal short. The TVL1000 carries a 2 year (730 days) limited warranty. Please fill • Disconnect from main power before making any type of connection. out the enclosed warranty card to validate your purchase and war- •...
  • Page 3 (ADJ part number Z-DMX/T) will decrease the possibilities of erratic Data Cable (DMX Cable) Requirements (For DMX and Master/Slave behavior. Operation): The TVL1000 3 DMX channel modes. The DMX address COMMON is set electronically using the controls on the side of the unit. Your unit...
  • Page 4: Control Panel

    16%, the indicator will blink fast reminding you that the battery is low and that it needs to be charged. The TVL1000 is fully operational in three different mounting positions, 3 Button: hanging upside-down from a ceiling, hanging sideways on truss-...
  • Page 5: Battery State

    TVL1000 System Menu System Menu. The TVL1000 comes with an easy to navigate system menu. To access the main menu press the MENU button. Tap the UP or DOWN buttons until you reach function you wish to change. When you reach the function you wish to change press the ENTER button.
  • Page 6 DMX set up. • LOAD (LED On or OFF) - This will let you blackout the LED while ©Elation Pr fessionals® - www.elationlighting.com - TVL1000 Instruction Manual Page 12 ©Elation Pr fessionals® - www.elationlighting.com - TVL1000 Instruction Manual Page 11...
  • Page 7 • STAT (Charge Status) - This will let you check the battery status. 1. The TVL1000 has three DMX channel modes. To set the chan- nel mode see page 10. See page 15 for the DMX modes & traits.
  • Page 8: Photometric Chart

    NOTE: Powered via battery does not mean that 5 fixtures are being powered by one battyer, each unit must have a battery connected. TVL1000 Photometric Chart ©Elation Pr fessionals® - www.elationlighting.com - TVL1000 Instruction Manual Page 15 ©Elation Pr fessionals® - www.elationlighting.com - TVL1000 Instruction Manual Page 16...
  • Page 9: Battery Installation

    Battery Installation TVL1000 Fuse Replacement The TVL1000 can also be powered by battery; Part# TVL- First unplug the power. Locate and remove the unit’s power cord. Once the cord has been removed located the fuse holder located 1000Bat (not included ). Connecting the battery is a very simple inside the power socket.
  • Page 10: Warranty

    Fuse: Power Cord Daisy Chain: 12 Fixtures Max. B. For warranty service, send the product only to the Elation® Professionals® factory. All shipping charges must be pre-paid. If the requested repairs or ser- Dimensions: 15.9”(L) x 13.7”(W) x 4.4”(H)

Table of Contents