Operating Instructions - Amana IC3 Installation And Operating Instructions Manual

19. Install straight end of ice maker arm in round hole in
water cup. Insert other end in elongated hole only; not
into round holes in ice maker housing. Ice maker arm
must be even with ice maker surface.
A. Hole in water cup
Installing ice maker arm
20. Slip stainless steel clip over rear wall of ice maker
water cup.
21. Select ice maker cover decorative insert that
resembles interior of refrigerator. Remove paper
backing from ice maker cover decorative insert.
Carefully position ice maker cover decorative insert on
ice maker cover and press on.
22. Remove and discard button plugs from side wall with
a knife covered with masking tape.
5
23. Start two / " (15 mm) sheet metal screws in top
8
holes on side wall with a
heads out approximately
24. Hold ice maker in position. Ice maker can only be
installed one way. Do not drill additional holes. Insert
wire harness plug into receptacle on rear wall until
locking fingers on top and bottom of plug snaps into
place. Slip ice maker hanger over sheet metal
screws. Ease ice maker water cup toward end of
water fill tube extension. Water fill tube extension fits
under stainless steel clip. Water fill tube extension
must not be kinked. Water fill tube extension must
extend approximately
cup and must be secured under stainless steel clip.
A
C
A. Water fill tube extension fits under stainless steel clip
B. Water fill tube extension
Fill tube extension into water cup
25. Install remaining 5 / " (15 mm) sheet metal screw and
8
tighten all 3 screws with a
26. Select ice storage bucket decorative insert that
resembles interior of refrigerator. Remove paper
backing from ice storage bucket decorative insert.
Carefully position ice storage decorative insert on ice
storage bucket then press on.
A
B
B. Ice maker arm
1
/ " hex nut driver. Leave
4
3 / " (9 mm).
8
3
/ " (9 mm) into ice maker water
8
B
C. Water cup
1
/ " hex nut driver.
4
27. Replace freezer shelf. Position ice storage bucket on
freezer shelf under ice maker.
28. Check for leaks at household plumbing connection
and water valve. Correct any leaks. Replace lower
cover on rear of refrigerator cabinet by placing cover
on refrigerator. Carefully tuck wires inside cover to
avoid pinching wires. Insert and tighten screws with a
1 / " hex nut driver.
4
29. Create service loop using extreme care to avoid
kinks. Copper tube must not extend more than
3 / " from back cover. Secure copper tubing at
8
back bottom horizontal cover using "P" clamp.
A. "P" clamp
securing copper tubing
!
To avoid property damage, all covers must be in place.
30. Move refrigerator in place and level if necessary.

Operating Instructions

• Confirm ice bucket is in place and ice maker arm is
down.
A. Off position
Ice maker installation
• After freezer section reaches normal temperature, ice
maker fills with water and begins operating. Allow 24-
48 hours after installation before first harvest of ice. Ice
maker produces 7 to 9 harvests of ice in a 24-hour
period under ideal conditions.
5
A
B
B. Copper tubing
CAUTION
B
B. On position
A