Motorola TLKR T40 Owner's Manual

68015000921_a.book Page 1 Tuesday, August 28, 2012 11:51 AM
Display
Preparing Your Radio
TLKR T40
Owner's Manual
Installing the Battery
1. Make sure your radio is OFF.
English
2. To remove the battery compartment door, by pressing the
3. Replace the battery compartment door.
Battery Level and Low Battery Alert
*68015000921*
68015000921-A(EN)
U01UT070ZZA
Printed in China
Basic Radio Operations
TLKR T40 Owner's Manual
EN
Read this reference guide completely before attempting to
Product Safety and RF Exposure for Portable
operate the unit.
Two-Way Radios
Turning Your Radio On/Off
Press and hold the MENU/
Before using this product, read the operating
OFF.
instructions for safe usage contained in the
Product Safety and RF Exposure booklet
Adjusting the Volume
Caution enclosed with your radio.
Adjust the volume by pressing the
Attention! Adjusting the Sound (Key Beeps)
Before using this product, read the RF energy awareness Your radio emits a beep each time one of the buttons is
information and operating instructions in the Product Safety
pressed (except the PTT button).
and RF Exposure booklet to ensure compliance with RF Press and hold the
energy exposure limits.
switch the sound OFF.
To turn this sound ON, turn the radio OFF and ON again
Package Contents
without pressing the
• TLKR T40 Radio* (2 units)
• Belt Clip (2 units) Selecting a Channel
• TLKR T40 Owner's Manual
In order to speak to someone, both your radios must be set to
the same channel.
To select a channel:
1. MENU/
2.
3. Press PTT button to confirm the selection.
Radio Controls Talking on Your Radio
1. Hold your radio 5–8 cm from your mouth.
2. Press and hold the PTT button while speaking. The
Antenna
3. Release the PTT button. You can now receive incoming
Note: When you continue to transmit for 60 seconds, the
Call Button
Navigating through the Menu
PTT
1. To enter the Menu, press the MENU/
Button
Volume/ 2. Additional presses of the MENU/
Menu/Power Channel
Buttons 3. To exit the Menu function, do one of the following:
button
a. Press and hold the MENU/
b.Press the PTT button.
Speaker
c.Wait 10 seconds until the unit automatically returns to
Microphone
Features on Your Radio
Call Tone
Your radio is equipped with a call tone.
To transmit a call tone, press the
Channel Scan Mode
Enables your radio to scan for active channels. When activity
is detected, your radio lands (stays) on that channel (for 2
1. Volume Level Indicator seconds). To transmit on that channel, press the PTT button.
4
1
2. Transmit/Receive When activity on the landed channel ends, your radio
5
Indicator continues scanning other channels.
2
3. Keypad Lock Indicator To turn the channel scan ON:
6 4. Scan Indicator 1. MENU/
5. Battery Level Meter 2. /
3
6. Channel Indicator
MENU/
Key Lock
Press and hold
tab at the bottom of the compartment door. Remove the Press and hold
door. Insert 3 AAA batteries into the battery compartment. keypad.
Indicates that the battery is fully charged.
Blinks when battery is low; replace batteries
immediately.
Monitor Mode
Enables you to listen for weak signals on the current channel.
To turn the Monitor Mode ON:
1. MENU/
until
button to turn your radio ON/
2. Press the
icon continues to blink.
To turn the Monitor Mode OFF:
Press the MENU/
and buttons.
icon stops blinking.
Roger Beep
Sounds to indicate the end of a PTT transmission. It can be
button while turning the radio ON to
heard through the speaker when Key Beep is on. It cannot be
heard through the speaker if Key Beep is turned off.
Press and hold the
button.
turn the Roger Beep ON. Repeat the step to turn Roger Beep
OFF.
Automatic Power Save
For better battery life, your radio is designed to switch to
Power Save mode when there has been no transmissions
button to enter Menu.
after 3 seconds. The radio can receive transmissions in this
or to the required channel.
mode.
Specifications
Channels
Frequency
appears on the display.
Power Source 3 AAA Alkaline Batteries
calls. When you do, the appears on the display. To
Range
respond, repeat procedure from step 1.
Battery Life
*Range may vary depending on environmental and/or topographical
radio emits TX Time Out tone and the icon
conditions.
flashes. The radio will stop transmitting.
Frequency Chart
Channel
button.
buttonwill advance you
through the Menu.
button.
"Normal" mode.
/ button.
Warranty Information
The authorized Motorola dealer or retailer where you
purchased your Motorola two-way radio and/or original
accessories will honour a warranty claim and/or provide
warranty service.
Please return your radio to your dealer or retailer to claim
your warranty service. Do not return your radio to Motorola.
to enter Menu. Advance until blinks. In order to be eligible to receive warranty service, you must
to turn ON channel scan. present your receipt of purchase or a comparable substitute
proof of purchase bearing the date of purchase. The two-way
or PTT to turn OFF Scan mode.
radio should also clearly display the serial number. The
warranty will not apply if the type or serial numbers on the
product have been altered, deleted, removed, or made
/ until appears to lock the keypad.
illegible.
/ until disappears to unlock the
What Is Not Covered By The Warranty
Defects or damage resulting from use of the Product in other
than its normal and customary manner or by not following the
button to enter menu.Advance through the menu instructions in this user manual.
icon blinks. Defects or damage from misuse, accident or neglect.
Defects of damage from improper testing, operation,
/ button for continuous listening. The
maintenance, adjustment, or any alteration or modification of
any kind.
Breakage or damage to aerials unless caused directly by
button to return to "Normal" mode. The
defects in material or workmanship.
Products disassembled or repaired in such a manner as to
adversely affect performance or prevent adequate inspection
and testing to verify any warranty claim.
Defects or damage due to range.
Defects or damage due to moisture, liquid or spills.
All plastic surfaces and all other externally exposed parts that
button while turning the radio ON to
are scratched or damaged due to normal use.
Products rented on a temporary basis.
Periodic maintenance and repair or replacement of parts due
to normal usage, wear and tear.
Copyright Information
The Motorola products described in this manual may include
8 PMR
copyrighted Motorola computer programs stored in
446.00625 - 446.09375 MHz
semiconductor memories or other media. Laws in the United
States and other countries preserve for Motorola certain
exclusive rights for copyrighted computer programs including,
Up to 4 km*
but not limited to, the exclusive right to copy or reproduce in
16 Hours (under typical use conditions)
any form the copyrighted computer program. Accordingly,
any copyrighted Motorola computer programs contained in
the Motorola products described in this manual may not be
copied, reproduced, modified, reverse-engineered, or
Freq. (MHz) Channel Freq. (MHz)
distributed in any manner without the express written
1 446.00625 5 446.05625 permission of Motorola. Furthermore, the purchase of
Motorola products shall not be deemed to grant either directly
2 446.01875 6 446.06875
or by implication, estoppel, or otherwise, any license under
3 446.03125 7 446.08125
the copyrights, patents or patent applications of Motorola,
4 446.04375 8 446.09375
except for the normal non-exclusive license to use that arises
by operation of law in the sale of a product.
MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the
Stylized M logo are trademarks or registered trademarks of
Motorola Trademark Holdings, LLC and are used under
license. All other trademarks are the property of their
respective owners.
© 2012 Motorola Solutions, Inc. All rights reserved.
Notes
Notes