Canon PIXMA iP6600D Series Quick Start Manual page 42

Troubleshooting
Problem
I
Possible Cause
I
Try This
Printed Surface is Thick paper is used
Scratched
Select the Prevent paper abrasion check box to widen the clearance between
the Print Head and the loaded paper.
WNote
Clear the Prevent paper abrasion check box once printing is
complete.
Media is curled
~.
1. Open the printer properties dialog box.
2. Click the Maintenance tab and then Custom Settings.
~Important
In Windows XP and Windows
2000
When not logged on as a computer administrator or
Administrators, you cannot open the Custom Settings dialog
box.
For further information on how to log on as an administrator,
refer to your Windows documentation.
3. Select the Prevent paper abrasion check box and click Send.
Click OK when the confirmation message appears.
Or'
1. Open the Canon IJ Printer Utility dialog box.
2. Select Custom Settings from the pop-up menu.
3. Select Prevent paper abrasion.
When Prevent paper abrasion is selected in the printer properties dialog box
(Windows) or selected from Custom Settings in the Canon IJ Printer Utility
dialog box (Macintosh), the setting is also applied under direct printing with
the digital camera.
If aU four corners or the printing surface of the paper is curled, the paper may
become dirty or the paper may not feed properly. Use the paper after
correcting paper curl as follows.
1. Face up the printing surface
*1,
and cover it with a non-printing regular
paper to avoid damaging the surface.
2. Roll up the paper in a direction opposite to paper curl as the figure below.
(1) (2)
3. Check the
printing~aper
if paper is corrected within approximately 2 to 5
mm/0.08 to 0.2 in .
It is recommended to print the curl-corrected paper one sheet at a time.
*1