Beko WMB 91242 DLSC User Manual page 26

• Place a large container in front of the
filter to receive water flowing from the
filter.
• Loosen pump filter (anticlockwise) until
water starts to flow out of it. Direct the
flowing water into the container you
have placed in front of the filter. You
can use a piece of cloth to absorb any
spilled water.
• When there is no water left, turn the
pump filter until it is completely loose
and remove it.
• Clean any residues inside the filter
as well as fibers, if any, around the
propeller region.
• If your product has a water jet feature,
be sure to fit the filter into its housing
in the pump. Never force the filter
while replacing it into its housing.
Fit the filter fully into its housing;
otherwise, water may leak from the
filter cap.
4- Close the filter cap.
Close the two-piece filter cap of your
product by pushing the tab on it.
Close the one-piece filter cap of your
product by fitting the tabs on the bottom
into their positions and pushing the upper
part of it.
26
EN