Table of Contents
Advertisement
To replace one of these bulbs:
1. Using a small flat-bladed tool,
insert the blade end at the back
edge of the rear license plate
lamp housing (A).
2. Gently push forward while lifting
the back edge of the lamp
housing from the bumper
opening.
3. Turn the bulb socket (C)
one quarter turn to release the
bulb socket from the lamp
housing (A).
4. Pull the bulb (B) from the bulb
socket (C).
5. Reverse the steps to install.
Replacement Bulbs
Exterior Lamp
Number
Back-up Lamp
License
Plate Lamp
Rear Turn Signal
Lamp, Taillamp,
and Stoplamp
Sidemarker Lamp
For replacement bulbs not listed
here, contact your dealer.
I n f o r ma t i o n P r o v i d e d b y :
Vehicle Care
Electrical System
Bulb
Electrical System
Overload
7441
The vehicle has fuses and circuit
168
breakers to protect against an
electrical system overload.
When the current electrical load is
3057K
too heavy, the circuit breaker opens
and closes, protecting the circuit
194LL
until the current load returns to
normal or the problem is fixed. This
greatly reduces the chance of circuit
overload and fire caused by
electrical problems.
Fuses and circuit breakers protect
power devices in the vehicle.
Replace a bad fuse with a new one
of the identical size and rating.
If there is a problem on the road and
a fuse needs to be replaced, the
same amperage fuse can be
borrowed. Choose some feature of
the vehicle that is not needed to use
and replace it as soon as possible.
10-37
Advertisement
Chapters
Table of Contents
