IBM Network Color Printer Administrator's Manual page 70

B–4
Administrator's Guide
10. Wait a moment and then turn the printer back on. As the printer starts up,
booting and scanning messages are displayed.
11. Wait until the following message is displayed:
UPGRADE CODE NOW
YES
12. Press the Enter push button to upgrade the system microcode now.
(If you select NO, there will be a short delay, the printer will continue
initializing, and the upgrade option will display again the next time you turn
the printer on.)
If you select YES, the following message is displayed:
UPDATING CODE
DO NOT POWER OFF
Do not turn off power to the printer at this point. If you do so,
Attention:
you will damage the printer's hard disk.
13. Wait until the following message is displayed:
SELECT FUNCTION
RUN SETUP
14. Attach the Ethernet cable to the back of the printer.
15. What you do next depends on what the name of the printer should be and
whether or not the printer should be connected to a Novell NetWare server.
• If the name IBMnetcolor is acceptable and the printer is not connected
to a NetWare server, press the Menu push button to exit. The printer
initializes and enters a ready state.
• If the name of the printer needs to be something other than IBMnetcolor,
or if there were connections in place to a NetWare server before the
microcode upgrade, press the Enter push button to enter the setup
menus. Use the instructions in "Configuring the IBM Network Color
Printer" on page 6–1 to change the printer name and to review the
connections to the NetWare server. You may need to recreate the
connections to the NetWare server.
You have finished upgrading the printer microcode.
Note: Although the microcode is new, page count information, error log
information and most configuration information is saved.